Update 17th January 2024

Neurotrac Tens details and specifications

I. D. Stewart Pty. Ltd.

ABN 69 001 130 338

Suppliers of quality Physiotherapy and Rehabilitation Equipment.
Phone 02 9878 4217 (Australia)Mobile 0408 249 432
Send us an email idstewart@bigpond.com HOME PAGE BACK to TENS page


Neurotrac Tens details

The Neurotac Tens has an easy to read display, the output controled by the 2 + - buttons and 3 buttons for operating.

The Neurotrac Tens is a basic easy to use tens. The press buttons are large and self expanatory. The left + - buttons contol the output od channel A and the right + - chennel B. The centre top button is the ON/OFF switch. Press program to select one of the 11 pre-set programs.Press SET for 3 seconds to go to the Custom Programs.


Neurotrac Tens specifications

The Neurotrac Tens has a belt clip and uses a 9 volt battery

2 channels, output current 0-80mA on 500 ohm load.
Pulse width 50uS ti 300uS, frequency 2Hz to 200Hz.
Mode - continuous, burst or modulated.
Selectable treatment time - 1 minute to 12 hours.
Battery - 9 volt.
Dimentions - 119.2 x 69 x 28.7.
Weight - 0.1kg.



This information is given as guide to the options available with this device.
All details are subject to change without notice.
Refer to manufactures instruction book for full operating details.
Refer to a qualified medical practitioner or therapist for advice on use, treatment settings, frequency of use and contra indications.

Manufactured in Ireland.

I. D. Stewart Pty. Ltd.

ABN 69 001 130 338

56 Twin Road, North Ryde NSW 2113
Phone 02 9878 4217 (Australia) Mobile 0408 249 432
Send us an email idstewart@bigpond.com HOME PAGE BACK to TENS page

Copyright © I.D.Stewart Pty. Ltd. 2019 all rights reserved. CoffeeCup HTML Editor (www.coffeecup.com)